Differences
This shows you the differences between two versions of the page.
Both sides previous revision Previous revision Next revision | Previous revision | ||
cyberotter [2021/08/19 16:58] – [Device tree configuration] kristoffergryte | cyberotter [2022/09/19 11:34] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 28: | Line 28: | ||
==== SBG Driver Config ==== | ==== SBG Driver Config ==== | ||
- | TODO Øystein: Add more about the SBG config | + | We use a ROS driver for interfacing with SBG Ellipse 2D: https:// |
+ | |||
==== IMC - ROS Bridge ==== | ==== IMC - ROS Bridge ==== | ||
- | The IMC ROS bridge developed by the Swedish Maritime Robotics Centre (SMaRC) was used to map ROS topics from the SBG driver to the IMC format. The IMC messages were then transmitted from the Nvidia Jetson to DUNE running on the Beaglebone Black. | + | The IMC ROS bridge developed by the Swedish Maritime Robotics Centre (SMaRC) was used to map ROS topics from the SBG driver to the IMC format. The IMC messages were then transmitted from the Nvidia Jetson to DUNE running on the Beaglebone Black. |
- | TODO Øystein: Add more about the IMC ROS bridge. | ||
==== DUNE Navigation pipeline ==== | ==== DUNE Navigation pipeline ==== | ||
Line 199: | Line 201: | ||
=== ptp4l config === | === ptp4l config === | ||
- | '' | + | '' |
+ | The full config is in '' | ||
+ | |||
+ | The Jetson Xavier is a slave in the PTP setup. In '' | ||
=== phc2sys config === | === phc2sys config === | ||
Line 213: | Line 219: | ||
phc2sys -w -c CLOCK_REALTIME -s eth0 | phc2sys -w -c CLOCK_REALTIME -s eth0 | ||
</ | </ | ||
+ | |||
+ | |||
+ | === Useful commands === | ||
+ | |||
+ | Status PTP: < | ||
+ | Restart PTP: < | ||
+ | Check the status of every actor connected:< | ||
+ | Verify that the slaves are in fact configured to be slaves:< | ||
===== Yocto Linux configuration ===== | ===== Yocto Linux configuration ===== | ||
Line 225: | Line 239: | ||
* [[https:// | * [[https:// | ||
- | ==== Vision sensors ==== | + | ===== Vision sensors ===== |
- | + | The cameras and the LiDAR are interfaced through ROS drivers: | |
- | === Zed 2 stereo camera === | + | |
- | TODO Øystein: add config | + | |
- | + | ||
- | === FLIR Blackfly S === | + | |
- | TODO Øystein: add config | + | |
- | === Ouster OS-1 === | + | * ZED 2 stereo camera: https:// |
- | TODO Øystein: add config | + | * FLIR Blackfly S: https:// |
+ | | ||