stratopican_setup

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revision Previous revision
Next revision		 Previous revision
stratopican_setup [2021/06/14 09:17] – nikolalstratopican_setup [2022/09/19 11:34] (current) – external edit 127.0.0.1
Line 16: Line 16:
  
 ==== Watchdog ==== ==== Watchdog ====
 +  * ''XWED'' Set the watchdog enable mode to disabled (Badly named, in this mode, it's enabled by setting WatchdogEnable gpio pin from the RPI).
   * ''XWH00005'' Set timeout to 5 sec.   * ''XWH00005'' Set timeout to 5 sec.
 +  * ''XWW00001'' Set the watchdog forced shutdown timeout to 1sec(min).
   * ''XCCS''  Make configuration permanent.   * ''XCCS''  Make configuration permanent.
  
Line 32: Line 34:
  
  
-^ Board      ^ Firmware       ^ Watchdog ^ RS-485 ^ Location ^ Note ^ +^ Board      ^ Firmware       ^ Configured ^ Location ^ Note ^ 
-| SPBC12X-FX314618SC-296 | 3.5 | Configured |  | ntnu-otter-01 | | +| SPBC12X-FX314618SC-296 | 3.5 | X | Loose | | 
-| SPBC12X-FX314618SC-297 | 3.5 | Configured |  | Loose | PPS lever-shifter | +| SPBC12X-FX314618SC-297 | 3.5 | X | Loose | PPS lever-shifter | 
-| SPBC12X-FX314618SC-292 | 3.5 | Configured |  | Loose |  |+| SPBC12X-FX314618SC-292 | 3.5 | X | Loose |  | 
 +| SPBC12X-FX432220SC-F21200269 | 4.3/0.8 | X | ntnu-otter-02 |  | 
 +| SPBC12X-FX314618SC-F21200097 | 4.3/0.8 | X | ntnu-otter-01 |  | 
 +| SPBC12X-FX314618SC-F21200301 | 4.3/0.8 | X | ntnu-otter-03 |  | 
  • stratopican_setup.1623655038.txt.gz
  • Last modified: 2022/09/19 11:33
  • (external edit)